Component Tests and General Diagnostics
CRANKSHAFT POSITION SENSOR REMOVAL1. REMOVE RH FENDER APRON SEAL
2. REMOVE CRANKSHAFT POSITION SENSOR
(a) Remove the bolt and disconnect the crankshaft position sensor.
Torque: 8 Nm (80 kgf.cm, 69 in.lb)
(b) Disconnect the crankshaft position sensor connector.
CRANKSHAFT POSITION SENSOR INSPECTION
NOTICE: "Cold" and "Hot" In the following sentences express the temperature of the sensor itself.
"Cold" is from -10°C (14°F) to 50°C (122°F).
"Hot" is from 50°C (122°F) to 100°C (212°F).
- INSPECT CRANKSHAFT POSITION SENSOR RESISTANCE
- Using an ohmmeter, measure the resistance between terminals.
Resistance:
- Cold: 1.630 - 2,740 Ohms
- Hot: 2,065 - 3,225 Ohms
- If the resistance is not as specified, replace the crankshaft position sensor.
CRANKSHAFT POSITION SENSOR INSTALLATION
- INSTALLATION IS IN THE REVERSE ORDER OF REMOVAL.