Input Signal Check

INPUT SIGNAL CHECK PROCEDURES











Output of Code
1. (a) For check No.1 No.2
Turn the ignition switch ON.
(b) For check No.3 No.6
(1) Turn the ignition switch ON.
(2) Shift to the D position.
(c) For check No.7 No.8
(1) Jack up the vehicle.
(2) Start the engine.
(3) Shift to D position.
2. Press the control switch to SET/COAST or RES/ACC position and hold it down (1) or up (1)'.
3. Push the main switch on (2)
4. Check that the CRUISE MAIN indicator light blinks twice or 3 times repeatedly after 3 seconds.
5. Turn the SET/COAST or RES/ACC switch off.
6. Operate each switch as listed in the table below.
7. Read the blinking pattern of the CRUISE MAIN indicator light.
8. After performing the check, turn the main switch off.

HINT: When two or more signals are input to the ECU, only the lowest-numbered code is displayed.