Crankshaft Position Sensor: Service and Repair

CRANKSHAFT POSITION SENSOR REMOVAL
1. DISCONNECT CRANKSHAFT POSITION SENSOR CONNECTOR FROM GENERATOR DRIVE BELT ADJUSTING BAR
2. REMOVE RH FENDER APRON SEAL
3. REMOVE NO.1 TIMING BELT COVER
4. REMOVE CRANKSHAFT POSITION SENSOR



- Remove the bolt and disconnect the crankshaft position sensor.

CRANKSHAFT POSITION SENSOR INSTALLATION
1. INSTALL CRANKSHAFT POSITION SENSOR
- Install the crankshaft position sensor with the bolt.

Torque: 9.5 Nm (95 kgf.cm, 82 in.lb)

2. INSTALL NO.1 TIMING BELT COVER
3. INSTALL RH FENDER APRON SEAL
4. CONNECT CRANKSHAFT POSITION SENSOR CONNECTOR TO GENERATOR DRIVE BELT ADJUSTING BAR