Transmission Position Sensor/Switch: Service and Repair

PARK/NEUTRAL POSITION SWITCH REPLACEMENT



1. DISCONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR

2. REMOVE PARK/NEUTRAL POSITION SWITCH
- Remove the clip from the shift control cable.



- Remove the nut and control cable.



- Remove the transaxle control shaft lever.
- Remove the park/neutral position switch.

3. INSTALL AND ADJUST PARK/NEUTRAL POSITION SWITCH



- Install the park/neutral position switch.



- Adjust the park/neutral position switch.



- Install the transaxle control shaft lever.



- Install the control cable and nut.

Torque: 15 Nm (150 kgf.cm, 11 ft.lb)

- Install the clip to the shift control cable.

4. CONNECT PARK / NEUTRAL POSITION SWITCH CONNECTOR
5. TEST DRIVE VEHICLE