Throttle Position Sensor: Adjustments

THROTTLE POSITION SENSOR ADJUSTMENT



- Loosen the 2 set screws of the sensor.



- Insert a 0.60 mm (0.024 in.) feeler gauge between the throttle stop screw and stop lever.



- Connect the tester probe of an ohmmeter to the terminals IDL and E2 of the sensor.



- Gradually turn the sensor clockwise until the ohmmeter deflects, and secure it with the 2 set screws.



- Recheck the continuity between terminals IDL and E2.

Clearance between Continuity
lever and stop screw (IDL - E2)

0.50 mm (0.020 in) Continuity
0.70 mm (0.028 in) No Continuity