Air Bag Control Module: Service and Repair

AIRBAG SENSOR ASSEMBLY REMOVAL AND INSTALLATION

NOTICE:
- Do not open the cover or the case of the ECU and various computers unless absolutely necessary. (If the IC terminals are touched, the IC may be destroyed by static electricity.)
- Never use SRS parts from another vehicle. When replacing parts, replace with new parts.
- Never reuse the airbag sensor assembly involved in a collision when the airbag has deployed.
- Never repair a sensor in order to reuse it.

1. REMOVE THESE PARTS



- Console Box
- Center Cluster Finish Panel
- Lower Center Finish Panel
- Rear Air Duct No.3

2. REMOVE AIRBAG SENSOR ASSEMBLY
(a) Disconnect the connector.

NOTICE:
Removal of the connector is done with the sensor assembly installed.

(b) Using a torx wrench, remove the 3 screws and the airbag sensor assembly.
Torx wrench: T40 (Part No.09042-00020 or locally manufactured tool)

3. INSTALL AIRBAG SENSOR ASSEMBLY
(a) Using a torx wrench, install the airbag sensor assembly with the 3 screws.
Torx wrench: T40 (Part No.09042-00020 or locally manufactured tool)

Torque: 20 N.m (200 kgf.cm, 14 ft.Ibf)

(b) Connect the connector.

NOTICE:
- Installation of the connector is done with the sensor assembly installed.
- Make sure the sensor assembly is installed to the specified torque.
- If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case. bracket or connector. replace the sensor assembly with a new one.
- When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.
- After installation, shake the sensor assembly to check that there is no looseness.

4. INSTALL THESE PARTS
- Rear Air Duct No.3
- Lower Center Finish Panel
- Center Cluster Finish Panel
- Console Box