Federal Vehicles

IGNITION CABLES INSPECTION
1. Disconnect high-tension cords from spark plugs.



- Disconnect the cords at the rubber boot.
- NOTE: Pulling on or bending the cords may damage the conductor inside.
2. Disconnect high-tension cords from distributor cap.



a. Using a screwdriver, lift up the lock claw and disconnect the holder from the distributor cap.
b. Disconnect the high-tension cord at the grommet.
3. Inspect high-tension cord resistance.



- Using an ohmmeter, measure the resistance.

Maximum resistance: 25 k Ohms per cord

- If the resistance is greater than maximum, replace the high-tension cord.
4. Reconnect high-tension cords to distributor cap.



a. Install the grommet portion into the terminal hole of the distributor cap.



b. Align the spline of the distributor cap with the spline of the holder, and slide on the holder.



NOTE: Check that the holder is correctly installed to the grommet and distributor cap as shown in the illustration.



c. Check that the lock claw of the holder is engaged by lightly pulling the holder.



d. Check that the high-tension cords are connected as shown in the illustration.
5. Reconnect high-tension cords to spark plugs.



- Secure the high-tension cords with the clamps as shown in the illustration.