Front Airbag Sensor Assembly

NOTICE:
- If the wiring connector of the SRS is disconnected with the ignition switch at ON or ACC., diagnostic trouble codes will be recorded.
- Never use SRS parts from another vehicle. When replacing parts, replace with new parts.
- Never reuse the sensor involved in a collision when the SRS has deployed.
- Never repair a sensor in order to reuse it.

1. REMOVE FOLLOWING PARTS:
(a) Hood lock protector rear plate
(b) Headlight door

2. REMOVE FRONT AIRBAG SENSOR
(a) Disconnect the connector.
(b) Remove the bolt, the nut and the sensor.

3. INSTALL FRONT AIRBAG SENSOR






Install the sensor with the arrow on the sensor facing toward the front of the vehicle. Torque: 25 N.m (260 kgf.cm. 19 ft.lbf).

NOTICE:
- Make sure the sensor is installed to the specified torque.
- If the sensor has been dropped, or there are cracks, dents, or other defects in the case, brackets or connector, replace the sensor. If removed, always replace the set bolt and the nut with new one.
- The sensor set bolt and the nut have been anti-rust treated. When the sensor is removed, always replace the set bolt and the nut with new ones.
- After installation, shake the sensor to check that there is no looseness.
- The front sensor is equipped with an electrical connection check mechanism. Be sure to lock this mechanism securely when connecting the connector. If the connector is not securely locked, a malfunction code will be detected by the diagnosis system.
- Inspect for body damage where the front airbag sensor is installed

(The SRS may malfunction, or may not work, if the dimensions of the sensor mount is not correct.)

4. INSTALL FOLLOWING PARTS:
(a) Headlight door
(b) Hood lock protector rear plate