Without Scan Tool

1. OUTPUT DIAGNOSTIC TROUBLE CODE
(a) Turn the ignition switch to ACC. or ON position and wait approx.. 20 seconds.

Tc and E1 Positions:

(b) Using SST, connect terminals Tc and E1 of the DLC1. SST 09843-18020

NOTICE:
Never make a mistake with the terminal connection position as this will cause a malfunction.

2. READ DIAGNOSTIC TROUBLE CODE
Read the diagnostic trouble code as indicated by the number of times the SRS warning light blinks.

Normal code indication.:

- The light will blink 2 times per second.

Malfunction code indication:

- In the event of a malfunction, the light will blink. The first number of the No. will equal the first digit of a 2- digit diagnostic trouble code, and after a 1.5 second pause, the 2nd number of the No. will equal the 2nd digit. If there are 2 or more codes, there will be a 2.5 second pause between each.
- After all the codes have been output, there will be a 4.0 second pause and they will all be repeated.

HINT:
- In the event of a number of trouble codes, indication will begin from the smaller numbered code to the larger.
- If a diagnostic trouble code is not output or is continuously output, proceed to the Tc terminal circuit inspection. Component Tests and General Diagnostics