Function of Components

1. STEERING WHEEL PAD (WITH AIRBAG)
The inflater and bag of the SRS are stored in the steering wheel pad and cannot be disassembled. The inflater contains a squib, igniter charge, gas generant, etc. and inflates the bag when instructed by the center airbag sensor assembly.





2. SPIRAL CABLE (IN COMBINATION SWITCH)
A spiral cable is used as an electrical joint from the vehicle body side to the steering wheel.





3. FRONT PASSENGER AIRBAG ASSEMBLY
The inflater and bag of the SRS are stored in the front passenger airbag assembly and cannot be disassembled. The inflater contains a squib, igniter charge, gas generant, etc. and inflates the bag when instructed by the center airbag sensor assembly.





4. SRS WARNING LIGHT
The SRS warning light is located on the cluster finish panel. It goes on to alert the driver of trouble in the system. When a malfunction is detected in the center airbag sensor assembly. In normal operating conditions when the ignition switch is turned to the ACC. or ON position, the light goes on for about 6 seconds and then goes off.





5. FRONT AIRBAG SENSOR
A front airbag sensor is mounted inside each of the front fenders. The sensor unit is a mechanical type. When the sensor detects deceleration force above a predetermined limit, contact is made in the sensor, sending a signal to the center airbag sensor assembly. The sensor cannot be disassembled.





6. CENTER AIRBAG SENSOR ASSEMBLY
The center airbag sensor assembly is mounted on the floor inside the console box. The center airbag sensor assembly consists of a center airbag sensor, safing sensor, diagnosis circuit and ignition control, drive circuit, etc. It receives signals from the airbag sensors and judges whether the SRS must be activated or not.