Spark Plug: Testing and Inspection

SPARK PLUGS INSPECTION

1. DISCONNECT HIGH-TENSION CORDS FROM SPARK PLUGS.
2. REMOVE SPARK PLUGS.
- Using a 16 mm plug wrench, remove the spark plug.
3. CLEAN SPARK PLUGS.





- Using a spark plug cleaner or wire brush, clean the spark plug.
4. VISUALLY INSPECT SPARK PLUGS.





- Check the spark plug for electrode wear, thread damage and insulator damage.
- If abnormal, replace the spark plug.

Recommended spark plug:
ND: K16R-U
NGK: BKR5EYA

5. ADJUST ELECTRODE GAP.





- Carefully bend the outer electrode to obtain the correct electrode gap.

Correct electrode gap: 0.8 mm (0.031 in.)

6. INSTALL SPARK PLUGS.
- Using a 16 mm plug wrench, install the spark plug.

Torque: 20 Nm (200 kgf.cm, 14 ft.lb)

7. RECONNECT HIGH-TENSION CORDS TO SPARK PLUGS.