On-Vehicle Inspection

ON-VEHICLE INSPECTION
1. INSPECT THROTTLE BODY.



- Check that the throttle linkage moves smoothly.
- Check the vacuum at each port.
- Start the engine.



- Check the vacuum with your finger




2. INSPECT THROTTLE POSITION SENSOR.
- Apply vacuum to the throttle opener.



- Disconnect the sensor connector.
- Insert a thickness gauge between the throttle stop screw and stop lever



- Using an ohmmeter, measure the resistance between each terminal.



- Reconnect the sensor connector.

3. INSPECT THROTTLE OPENER.
- Allow the engine to warm up to normal operating temperature.
- Check idle speed

Idle speed: 700 + 50 rpm

- Check throttle opener setting speed



- Disconnect the vacuum hose from the throttle opener, and plug the hose end.
- Check the throttle opener setting speed.

Throttle opener setting speed: 900 - 1,950 rpm

- If the throttle opener setting is not as specified, replace the throttle body.
- Stop the engine and reconnect the vacuum hose to the throttle opener.
- Start the engine and check that the idle speed returns to the correct speed.