Crankshaft Position Sensor: Service and Repair

REMOVAL
1. DISCONNECT NEGATIVE (-) TERMINAL CABLE FROM BATTERY.

CAUTION: Work must not be started for at least 90 seconds from the time the Ignition switch Is turned to the LOCK position and the negative (-) terminal cable is disconnected from the battery.

2. REMOVE RIGHT SIDE ENGINE UNDER COVER.



3. REMOVE RIGHT SIDE FENDER APRON SEAL.



4. DISCONNECT ENGINE WIRE. REMOVE THE 3 NUTS AND DISCONNECT THE ENGINE WIRE.



5. REMOVE CRANKSHAFT POSITION SENSOR.
- Remove the bolt and remove the Crankshaft Position Sensor.
- Disconnect the Crankshaft Position Sensor connector.

INSTALLATION
1. INSTALL CRANKSHAFT POSITION SENSOR.

Torque: 8 N.m (69 in lb)

2. CONNECT ENGINE WIRE.
3. INSTALL RIGHT SIDE FENDER APRON SEAL.
4. INSTALL RIGHT SIDE ENGINE UNDER COVER.
5. CONNECT NEGATIVE (-) TERMINAL CABLE TO BATTERY.