Variable Induction Control Solenoid: Testing and Inspection

1. REMOVE V-BANK COVER AND EMISSION CONTROL VALVE SET.
2. REMOVE VSV for ACIS.
- Disconnect the 2 vacuum hoses from the VSV for ACIS.
- Remove the screw and VSV for ACIS.

3. INSPECT VSV for ACIS.
A. Inspect VSV for ACIS for open circuit.



- Using an ohmmeter, check that there is continuity between each terminal.

Resistance: At 20°C (68°F): 33 - 39 Ohm

- If there is no continuity, replace the VSV for ACIS.

B. Inspect VSV for ACIS for ground.



- Using an ohmmeter, check that there is no continuity between each terminal and the body.
- If there is continuity, replace the VSV for ACIS.

C. Inspect VSV for ACIS operation.



- Check that air flows from port E to the filter.




- Apply battery positive voltage across the terminals.
- Check that air flows from port E to port F.

- If operation is not as specified, replace the VSV for ACIS.

4. REINSTALL VSV for ACIS.
- Install the VSV for ACIS with the screw.
- Connect the 2 vacuum to the VSV for ACIS.

5. REINSTALL EMISSION CONTROL VALVE SET.

6. REINSTALL V-BANK COVER.