Throttle Position Sensor: Adjustments

- Remove throttle body.
- Refer to Throttle Body service procedures.




- Loosen the 2 set screws of the sensor.




- Apply vacuum to the throttle opener.
- Insert a 0.54 mm (0.021 in.) thickness gauge, between the throttle stop screw and stop lever.




- Connect the test probe of an ohmmeter to the terminals IDL and E2 of the sensor.
- Gradually turn the sensor clockwise until the ohmmeter deflects, and secure it with the 2 set screws.
- Recheck the continuity between terminals IDL and E2.



- Reinstall throttle body.