Component Tests and General Diagnostics

1. REMOVE AIR CLEANER HOSE.
2. REMOVE RH ENGINE MOUNTING STAY.
3. REMOVE WATER OUTLET.
4. REMOVE KNOCK SENSORS.
- Disconnect the knock sensor connector.



- Using SST (09817-16011), remove the knock sensor.

5. INSPECT KNOCK SENSORS.



- Using an ohmmeter, check that there is no continuity between the terminal and body.
- If there is continuity, replace the sensor.

6. REINSTALL KNOCK SENSORS.
- Using SST, install the knock sensor.

Torque: 39 Nm (29 ft.lb)

- Connect the knock sensor connector.

7. REINSTALL WATER OUTLET.
8. REINSTALL RH ENGINE MOUNTING STAY.
9. REINSTALL AIR CLEANER HOSE.

SEE ALSO: Refer to DTC P0325, P0330, under the "Trouble Code Charts", for additional information.