Assembly of Shift and Select Lever Shaft

1. APPLY MP GREASE TO PARTS, AS SHOWN




2. INSTALL SHIFT AND SELECT LEVER SHAFT
Install the boot and shaft to the control shaft cover.

HINT: Make sure to install the boot in correct direction.

Position the air bleed of the boot downward.




3. INSTALL SNAP RING
Using a screwdriver and hammer, tap in the snap ring.




4. INSTALL SELECT INNER LEVER
a. Install the No.1 select spring seat, No.1 select spring and select inner lever.




b. Using a pin punch and hammer, drive in the slotted spring pin to the select inner lever.

Drive in depth: 0 ± 0.5 mm (0 ± 0.020 in.)




5. INSTALL SHIFT INTERLOCK PLATE AND NO.1 SHIFT INNER LEVER
a. Install the shift interlock plate No.1 shift inner lever.




b. Using a pin punch and hammer, drive in the slotted spring pin to the No.1 shift inner lever.

Drive in depth: 0 ± 0.5 mm (0 ± 0.020 in.)

c. Check that the shift interlock plate turns smoothly.




6. INSTALL NO.2 SHIFT INNER LEVER
a. Install the No.2 shift inner lever.




b. Using a pin punch and hammer, drive in the slotted spring pin to the No.2 shift inner lever.

Drive in depth: 0 ± 0.5 mm (0 ± 0.020 in.)




7. INSTALL NO.2 COMPRESSION SPRING, NO.2 SELECT SPRING SEAT AND SNAP RING
a. Install the No.2 compression spring and No.2 select spring seat.




b. Using a screwdriver and hammer tap in the E-ring.