Terminal Measurement Using Volt/Ohmmeter

ECM PINOUT VALUES

When measuring the voltage or resistance of the connector part of the ECM, remove the locks as required in the following procedure and always insert the test probe into the connector from the wire harness side.

PREPARATION

(a) Turn the ignition switch to LOCK position.
(b) Disconnect the connectors from the ECM.
(c) To remove section "A" and "B", carefully pull outward the locks on both sides as shown in the illustration.




CAUTION: Pay attention to section "C" in the illustration which can be easily broken.

(d) Reconnect the connectors to the ECM.

Part 1:

Part 2:

Connector View/Terminal I.D.

Part 1:

Part 2:

Standard Values