Manual Shifting Test
MANUAL SHIFTING TESTHINT: With this test, it can be determined whether the trouble is within the electrical circuit or is a mechanical problem in the transaxle.
Location Of Solenoid Wire:
1. Disconnect Solenoid Wire.
2. Inspect Manual Driving Operation.
- Check that the shift and gear positions correspond with the table below.
Shift Position Gear Position
D Position O/D
2 Position 2nd
L Position 1st
R Position Reverse
P Position Pawl Lock
HINT: If the "L", "2" and "D" position gear positions are difficult to distinguish, perform the following road test:
While driving, shift through the "L", "2" and "D" positions. Check that the gear change corresponds to the shift position.
^ If any abnormality is found in the above test, the problem is in the transaxle itself.
3. Connect Solenoid Wire.
4. Cancel Out diagnostic trouble code.
Clearing Trouble Codes