Installation

For removal information, see Removal
Removal




1. Install EGR Gas Temperature Sensor



(a) Install the sensor.
Torque: 20 Nm (14 ft lb)
(b) Connect the sensor connector. and install the sensor connector to the bracket on the No.1 Intake Manifold stay.

2. Install Throttle Body




(a) Attach a new gasket to the Intake Manifold, with the protrusion facing downward.



(b) Type A: Install the throttle body with the 4 bolts.
Torque: 19 Nm (14 ft lb)

HINT: Different bolt lengths are used for the upper and lower sides.

Bolt length:
Upper side - 45 mm (1.77 in)
Lower side - 55 mm (2.17 in.)
(c) Type B:
- Install the throttle body with the 2 bolts and 2 nuts.
Torque: 19 Nm (14 ft lb)
(d) Connect the following hoses:



(1) Vacuum hose (from upper port of TVV for EVAP) to port "P" of throttle body
(2) Vacuum hose (from port "Q" of EGR Vacuum Modulator) to port "E" of throttle body
(3) Vacuum hose (from port "R" of EGR Vacuum Modulator) to port "R" of throttle body
(4) PCV hose (from cylinder head) to throttle body

3. Connect Control Cables To Throttle Body



- Connect the following cables:
(1) Accelerator cable
(2) A/T throttle control cable

4. Install air cleaner Cap
(a) Connect the air cleaner hose to the throttle body.
(b) Install the air cleaner cap to the air cleaner case with the 4 clamps.
(c) Tighten the hose clamp.
(d) Connect the following connector, cord, cables and hoses:



(1) IAT sensor connector
(2) California only: High-tension cord to air cleaner hose
(3) Accelerator cable to clamp
(4) Cruise control actuator cable to clamps
(5) California only: Air hose for idle-up to air cleaner hose

5. Connect Negative (-) Terminal Cable To Battery