Removal

1. REMOVE NEGATIVE BATTERY CABLE
2. REMOVE AIR CLEANER CASE ASSEMBLY WITH AIR HOSE
3. REMOVE CLUTCH RELEASE CYLINDER AND TUBE CLAMP




4. DISCONNECT BACK-UP LIGHT SWITCH CONNECTOR




5. DISCONNECT CONTROL CABLES
a. Remove the clips and washers.
b. Remove the retainer from the cables.




6. REMOVE CLUTCH RELEASE CYLINDER BRACKET WITH EARTH CABLE




7. REMOVE TRANSAXLE MOUNTING BOLTS OF TRANSAXLE UPPER
8. RAISE VEHICLE

NOTE: Be sure the vehicle is securely supported.

9. REMOVE UNDER COVERS
10. DRAIN TRANSAXLE OIL
11. DISCONNECT SPEEDOMETER CABLE




12. DISCONNECT BOTH DRIVE SHAFTS. Service and Repair




13. REMOVE REAR ENGINE MOUNTING BRACKET
14. REMOVE STARTER
Remove the mounting bolts and lay the starter alongside the engine.




15. DISCONNECT LEFT ENGINE MOUNTING
a. Raise the transaxle and engine slightly with a jack and wooden block in between.
b. Disconnect the left engine mounting.




16. REMOVE TRANSAXLE
a. Remove the transaxle mounting bolts from the engine.
b. Lower the engine left side and remove the transaxle from the engine.