Ignition Cable: Testing and Inspection

V-Bank Cover:

- Using a 5 mm hexagon wrench, remove the two nuts and V-bank cover.

Wire Removal:

- Disconnect the high - tension cords at the rubber boot.


NOTICE: Pulling on or bending the cords may damage the conductor inside.

Wire Holder:

- Using a screwdriver, lift up the lock claw and disconnect the holder from the distributor cap (ignition coil).

Wire Removal:

- Disconnect the high-tension cord at the grommet. DO NOT pull on the cord.

NOTICE:
^ Pulling on or bending the cords may damage the conductor inside.
^ Do not wipe any of the oil from the grommet after the high-tension cord is disconnected.

Checking Resistance:

- Using an ohmmeter, measure the resistance

Maximum resistance: 25k ohms

- If the resistance is greater than maximum, check the terminals.
- If necessary, replace the high - tension cord.