Door Lock Signal

DOOR LOCK SIGNAL




HINT: When the relay circuit is as specified, inspect the door lock signal.

(a) Connect the connector to the relay.

(b) Connect the positive (+) lead from the voltmeter to terminal 3 and the negative (-) lead to terminal 4.

(c) Set the door lock manual switch to UNLOCK, check that the voltage rises from 0 V to battery voltage for approximately 0.2 seconds.





(d) Reverse the polarity of the voltmeter leads.

(e) Set the door lock manual switch to LOCK, check that the voltage rises from 0 V to battery voltage for approximately 0.2 seconds.

If operation is not as specified, replace the relay.