Disassembly of Shift and Select Lever Shaft

1. REMOVE CONTROL SHIFT LEVER. DUST BOOT AND CONTROL SHAFT COVER
a. Remove the lever lock pin and nut.
b. Remove the control shift lever.
c. Remove the dust boot.
d. Remove the control shaft cover.




2. REMOVE REVERSE RESTRICT PIN HOLDER AND NO.2 SHIFT INNER LEVER
a. Remove the E-ring.




b. Remove the reverse restrict pin holder, spring and No.2 shift inner lever.




3. REMOVE SHIFT FORK LOCK PLATE, NO.1 SHIFT INNER LEVER AND SHIFT INTERLOCK PLATE
a. Using a pin punch and hammer, drive out the slotted spring pin.




b. Remove the shift fork lock plate, No.1 shift inner lever, spring and shift interlock plate.




4. REMOVE E-RING FROM SELECT LEVER SHAFT




5. IF NECESSARY, REPLACE CONTROL SHAFT COVER OIL SEAL
a. Using a screwdriver, pry out the oil seal.




b. Using SST and a hammer, drive in a new oil seal until its surface is flush with the cover surface.
SST 09608-20012 (09608-00080, 09608-03020)
c. Coat the lip of the oil seal with MP grease.