Removal
1. DISCONNECT NEGATIVE BATTERY TERMINAL2. REMOVE AIR FLOW METER AND AIR CLEANER
3. DISCONNECT TRANSMISSION WIRE CONNECTOR AND NEUTRAL START SWITCH CONNECTOR
4. DISCONNECT GROUND STRAP
5. DISCONNECT THROTTLE CABLE FROM THROTTLE LINKAGE AND BRACKET
6. REMOVE TRANSMISSION CASE PROTECTOR
7. DISCONNECT SPEEDOMETER CABLE
8. DISCONNECT CONTROL CABLE
a. Remove the clip.
b. Remove the retainer.
c. Disconnect the control cable.
9. DISCONNECT OIL COOLER HOSES
10. REMOVE STARTER MOTOR SET BOLTS
11. REMOVE THE TWO TRANSMISSION HOUSING SET BOLTS
12. REMOVE ENGINE REAR MOUNT INSULATOR BRACKET SET BOLT
13. RAISE VEHICLE AND DRAIN TRANSAXLE
14. REMOVE LH FRONT FENDER APRON SEAL
Remove two bolts and two clips.
15. DISCONNECT BOTH DRIVE SHAFTS
Loosen the six nuts while depressing the brake pedal.
16. REMOVE SUSPENSION LOWER CROSSMEMBER
17. REMOVE CENTER DRIVE SHAFT
a. Using pliers, remove the snap ring.
b. Remove the bolt on the bearing bracket.
c. Pull out the center drive shaft.
18. REMOVE ENGINE MOUNTING CENTER MEMBER
a. Disconnect the control cable clamps.
b. Remove the eight bolts, two nuts and engine mounting center member.
19. REMOVE STABILIZER BAR
20. REMOVE LEFT STEERING KNUCKLE FROM LOWER ARM
a. Disconnect the steering knuckle from the lower arm.
b. Pull the steering knuckle toward the outside and remove the drive shaft.
21. REMOVE ENGINE REAR END PLATE
22. REMOVE TORQUE CONVERTER MOUNTING BOLTS
a. Turn the crankshaft to gain access to each bolt.
b. Hold the crankshaft pulley bolt with a wrench, remove the six bolts.
23. REMOVE ENGINE REAR MOUNTING BOLTS
a. Hold the engine and transaxle with two jacks, or a chain block and jack.
b. Remove the two engine rear mounting bolts.
24. REMOVE TRANSAXLE ASSEMBLY
a. Lower the rear end of the transaxle, remove the three transaxle housing mounting bolts.
b. Remove the transaxle from the engine.
25. REMOVE TORQUE CONVERTER FROM TRANSAXLE