System Check Procedure

PREPARATION OF TROUBLESHOOTING

1. Remove the glove box door and glove box.

2. Remove the ECU with the wire harness.

EFI SYSTEM CHECK PROCEDURE

1. The Electronic Fuel Injection (EFI) circuit can be checked by measuring the resistance and the voltage at the wiring connectors of the ECU.

2. Perform all voltage measurements with the connectors connected.

3. Verify that the battery voltage is 11 V or above when the ignition switch is "ON".





4. Using a voltmeter, measure the voltage at each terminal of the wiring connector.

Pinout Values and Diagnostic Parameters