System Check Procedure
PREPARATION OF TROUBLESHOOTING1. Remove the Electronic Control Unit (ECU) cover under the center console.
2. Remove the ECU with the wire harness.
EFI SYSTEM CHECK PROCEDURE
NOTE:
- The EFI circuit can be checked by measuring the resistance and the voltage at the wiring connectors of the ECU.
- Perform all voltage measurements with the connectors connected.
- Verify that the battery voltage is 11 V or above when the ignition switch is "ON".
Using a voltmeter with high impedance (10 k-ohms)/V minimum), measure the voltage at each terminal of the wiring connector.
Connector View
Terminal Identification
Standard Values
NOTE: If there is any problem, proceed with test indicated in left column of table.