Differential and Drive Pinion (Part 3)

INSTALLATION OF DIFFERENTIAL




1. INSTALL DIFFERENTIAL

2. INSTALL TRANSAXLE HOUSING




a. Remove any packing material and be careful not to oil on the contacting surfaces of the transaxle housing or transmission case.
b. Apply seal packing to the transaxle housing as shown.

Seal packing: Part No.08833-00090, THREE BOND 1131, LOCTITE No.518 or equivalent




c. Install and tighten the eighteen bolts.

Torque: 300 kg.cm (22 ft.lb, 29 N.m)

NOTE: Each bolt length (mm) is indicated in the image.




3. INSTALL OIL PUMP Service and Repair




4. INSTALL SPEED SENSOR
5. INSTALL SPEEDOMETER DRIVEN GEAR