Removal and Installation

1. REMOVE ENGINE WITH TRANSAXLE
INSTALL ENGINE WITH TRANSAXLE
2. REMOVE AND INSTALL TRANSAXLE AS SHOWN

MAIN POINT OF REMOVAL AND INSTALLATION




1. REMOVE TRANSAXLE ASSEMBLY

NOTE: When removing transaxle from engine, remove as the following procedure since cylinder block rib contacts transfer case.

a. Pull straight until there are space of 60 - 80 mm (2 - 3 in.) between engine and transaxle case.




b. Move the transmission case cover to the arrow in the illustration.




c. While holding transfer output slightly, pull out whole transaxle.

2. INSTALL TRANSAXLE ASSEMBLY FOLLOWING REMOVAL SEQUENCE IN REVERSE

REPLACEMENT OF TRANSAXLE GEAR OIL

1. DRAIN TRANSAXLE OIL
2. FILL TRANSAXLE OIL WITH GEAR OIL
Oil: Transaxle oil E50 (08885-80206) or equivalent

Recommended oil
Oil grade: API GL-5
Viscosity: SAE 75 W - 90 or 80 W - 90
Above - 18 °C (0 °C) SAE 90
Below - 18 °C (0 °C) SAE 80 W

Capacity: 4.8 Liters (5.1 US qts, 4.2 Imp qts)