Speedometer and Dynamometer Tests

SPEEDOMETER TEST OR OTHER TESTS
(Using Speedometer Tester or Chassis Dynamometer)





1. MOVE MODE SELECT LEVER TO "FF MODE" AND INSTALL SET BOLT

2. CONFIRM MODE SELECTION

CAUTION:
1. Do not drive the vehicle in 1st gear, 2nd gear or reverse while in the FF mode.
2. If it is necessary to move the vehicle, drive it in 3rd, 4th or 5th gear.
3. When desiring to back the vehicle, push it backwards manually.
4. Do not engage the clutch or pump the accelerator or brake pedal suddenly.





3. PLACE FRONT WHEELS ON TESTER ROLLERS

4. CHOCK REAR WHEELS

5. APPLY PARKING BRAKE

6. DISCONNECT INERTIA WEIGHT FROM TESTER ROLLER
(If equipped with it)

7. TEST VEHICLE
(1) Start the engine.
(2) Put the transmission in 3rd gear.
(3) Engage the clutch slowly, then gradually increase the speed as the test is conducted.

NOTE: The test should be conducted in 3rd, 4th and 5th gears.

(4) After the test is finished, reduce the speed gradually, then stop the engine.





8. AFTER FINISHING TEST, BE SURE TO MOVE MODE SELECT LEVER BACK TO "VISCOUS (NORMAL) MODE" AND LOCK IT SECURELY WITH SET BOLT.