Removal

1. REMOVE NEGATIVE BATTERY CABLE
2. REMOVE AIR CLEANER WITH AIR HOSE




3. REMOVE CLUTCH TUBE BRACKET
a. Remove the retainer from the bracket.
b. Remove the bolt and bracket.
4. REMOVE CLUTCH RELEASE CYLINDER AND TUBE CLAMP




5. DISCONNECT CONTROL CABLES
a. Remove the clips and washers.
b. Remove the retainer from the cables.




6.-1 (35-FE)
REMOVE BATTERY AND STARTER
a. Remove the battery.
b. Disconnect the cable and connector.
c. Remove the starter with the two bolts.




6.-2 (35-GE)
REMOVE STARTER
a. Disconnect the cable and connector.
b. Remove the starter with the two bolts.

7. DISCONNECT BACK-UP LIGHT SWITCH CONNECTOR AND GROUND STRAP




8. REMOVE TRANSAXLE MOUNTING BOLTS OF TRANSAXLE UPPER
9. RAISE VEHICLE

CAUTION: Be sure the vehicle is securely supported.

10. REMOVE UNDER COVERS
11. DRAIN OUT FLUID
12. DISCONNECT SPEEDOMETER CABLE




13. DISCONNECT EXHAUST PIPE FROM MANIFOLD




14. REMOVE SUSPENSION LOWER CROSSMEMBER




15. DISCONNECT FRONT AND REAR MOUNTINGS
a. Remove the two covers from the member.
b. Remove the four bolts.




16. REMOVE ENGINE MOUNTING CENTER MEMBER
17. DISCONNECT BOTH DRIVE SHAFTS FROM TRANSAXLE. Service and Repair




18. DISCONNECT LEFT STEERING KNUCKLE FROM LOWER ARM
a. Disconnect the steering knuckle from the lower arm.
b. Pull the steering knuckle toward the outside and remove the drive shaft.




19. DISCONNECT LEFT ENGINE MOUNTING
a. Raise the transaxle and engine slightly with a jack and wooden block in between.
b. Disconnect the left engine mounting.




20. REMOVE TRANSAXLE
a. Remove the transaxle mounting bolts from the engine.
b. Lower the engine left side and remove the transaxle from the engine.