Removal

1. DISCONNECT NEGATIVE BATTERY TERMINAL
2. REMOVE AIR FLOW METER
3. DISCONNECT THE THREE CONNECTORS




4. DISCONNECT SPEEDOMETER CABLE




5. DISCONNECT THROTTLE CABLE FROM THROTTLE LINKAGE AND BRACKET




6. DISCONNECT GROUND STRAP




7. REMOVE STARTER MOTOR SET BOLTS
8. REMOVE THE TWO TRANSMISSION HOUSING SET BOLTS




9. REMOVE ENGINE REAR MOUNT INSULATOR BRACKET SET BOLT
10. RAISE VEHICLE AND DRAIN TRANSAXLE
11. REMOVE ENGINE UNDER COVERS




12. REMOVE SUSPENSION LOWER CROSSMEMBER




13. DISCONNECT FRONT AND REAR MOUNTING
a. Remove the two dust covers from the center member.
b. Remove the four bolts




14. REMOVE ENGINE MOUNTING CENTER MEMBER
a. Disconnect the two clamps.
b. Remove the four bolts and engine mounting center member.




15. REMOVE LH DRIVE SHAFT
16. DISCONNECT RH DRIVE SHAFT




17. DISCONNECT EXHAUST PIPE FROM MANIFOLD




18. REMOVE STIFFENER PLATE




19. DISCONNECT CONTROL CABLE
a. Remove the clip.
b. Remove the retainer.
c. Disconnect the control cable from the bracket and remove the control cable bracket.




20. DISCONNECT OIL COOLER HOSES




21. REMOVE ENGINE REAR END PLATE




22. REMOVE TORQUE CONVERTER MOUNTING BOLTS
a. Turn the crankshaft to gain access to each bolt.
b. Hold the crankshaft pulley nut with a wrench, remove the six bolts.

23. REMOVE ENGINE REAR MOUNTING SET BOLTS




a. Hold the engine and transaxle with two jacks, or a chain block and jack.




b. Remove the two engine rear mounting set bolts.




24. REMOVE TRANSAXLE MOUNTING BOLTS
25. REMOVE TORQUE CONVERTER FROM TRANSAXLE