No. 1 One-Way Clutch and Sun Gear

DISASSEMBLY OF NO.1 ONE-WAY CLUTCH AND SUN GEAR




1. CHECK OPERATION OF ONE-WAY CLUTCH
Hold the sun gear and turn the hub.
The hub should turn freely clockwise and should lock counterclockwise.




2. REMOVE SECOND BRAKE HUB AND ONE-WAY CLUTCH FROM SUN GEAR
While turning the hub clockwise, remove the one-way clutch from the sun gear.




3. REMOVE NO.3 PLANETARY CARRIER THRUST WASHER FROM SUN GEAR INPUT DRUM
4. REMOVE SHAFT SNAP RING AND REMOVE SUN GEAR INPUT DRUM
5. REMOVE SHAFT SNAP RING

INSPECTION OF NO.1 ONE-WAY CLUTCH



1. IF NECESSARY, REPLACE ONE-WAY CLUTCH
a. Pry off the retainer with a screwdriver.
b. Remove the one-way clutch.




c. Install a new one-way clutch into the brake hub, facing the spring cage inward from the flanged side of the brake hub.




d. Hold the brake hub in a soft jaw vise, and flatten the ears with a chisel.
e. Check to make sure that the retainer is centered.

2. CHECK OPERATION OF ONE-WAY CLUTCH

ASSEMBLY OF NO.1 ONE-WAY CLUTCH AND SUN GEAR
1. INSTALL SHAFT SNAP RING ON SUN GEAR
2. INSTALL SUN GEAR INPUT DRUM ON SUN GEAR AND INSTALL SHAFT SNAP RING



3. INSTALL NO.3 PLANETARY CARRIER THRUST WASHER ON SUN GEAR INPUT DRUM
4. INSTALL ONE-WAY CLUTCH AND SECOND BRAKE HUB ON SUN GEAR
While turning the hub clockwise, slide the one-way clutch onto the sun gear.




5. RECHECK OPERATION OF NO.1 ONE-WAY CLUTCH