C51/4A-C Engine
1. REMOVE NEGATIVE BATTERY CABLE WIRE2. REMOVE AIR CLEANER WITH AIR HOSE
3. DISCONNECT BACK-UP LIGHT SWITCH CONNECTOR
4. REMOVE SPEEDOMETER CABLE
5. DISCONNECT CONTROL CABLE
a. Remove the two clips and washers.
b. Remove the two retainers and control cables.
6. REMOVE WATER INLET
a. Remove the bolt and nut holding the water inlet to the transaxle.
b. Remove the water inlet from the transaxle.
7. REMOVE CLUTCH RELEASE CYLINDER
8. REMOVE UNDER COVER
9. REMOVE FRONT MOUNTING AND REAR MOUNTING
a. Remove the cover from the member.
b. Disconnect the front and rear mounting.
10. REMOVE ENGINE MOUNTING CENTER MEMBER
11. DISCONNECT DRIVE SHAFT FROM TRANSAXLE
a. Remove the protector from the transaxle.
b. Disconnect the drive shaft with nuts.
12. REMOVE LEFT DRIVE SHAFT
a. Disconnect the steering knuckle from the lower arm.
b. Pull the steering knuckle outward, and remove the left drive shaft.
13. REMOVE STARTER
a. Disconnect the cable and connector.
b. Remove the starter with the two bolts.
14. DISCONNECT GROUND STRAP
15. REMOVE NO.2ENGINE REAR PLATE
16. REMOVE LEFT ENGINE MOUNTING
a. Raise the transaxle and engine slightly with a jack and wooden block in between.
b. Disconnect the left engine mounting.
17. REMOVE TRANSAXLE
a. Disconnect the transaxle mounting bolts from the engine.
b. Lower the engine left side and remove the transaxle from the engine.