Inspection of Overdrive Direct Clutch

INSPECTION OF OVERDRIVE DIRECT CLUTCH



1. INSPECT OVERDRIVE DIRECT CLUTCH PISTON
(a) Check that check ball is free by shaking the piston.
(b) Check that the valve does not leak by applying low- pressure compressed air.




2. INSPECT DISC, PLATE AND FLANGE
Check that the sliding surface of disc is not worn or burnt.
If a disc is worn or burnt, replace all discs.
Then check that the sliding surfaces of plate and flange are not worn or burnt. If necessary, replace them.

NOTE: Do not allow the discs to dry out. Prepare new discs by soaking them at least two hours in ATF.