Assembly of Overdrive One-Way Clutch

ASSEMBLY OF OVERDRIVE ONE-WAY CLUTCH




1. INSTALL THE FOUR PLUGS INTO HOLE OF PINION SHAFT




2. INSTALL NO.3 OVERDRIVE PLANETARY THRUST WASHER
Install the thrust washer, facing the groove toward the overdrive case.




3. ASSEMBLE OVERDRIVE ONE-WAY CLUTCH
(a )Install the one-way clutch into the outer race.
(b) Install a retainer on both sides of the one-way clutch.




4. INSTALL OVERDRIVE ONE-WAY CLUTCH INTO HUB
Be sure that the one-way clutch is installed in the correct direction.




5. INSTALL RETAINING PLATE AND SNAP RING




6. CHECK OPERATION OF ONE-WAY CLUTCH
(a) Install the overdrive clutch into the one-way clutch.
(b) Hold the overdrive clutch and turn the intermediate shaft. The shaft should turn freely clockwise and should lock counterclockwise.
(c) Remove overdrive clutch from the one-way clutch.