Camry Wagon Back Door Parts & Tools

CAMRY BACK DOOR MODIFICATION PROCEDURE



PARTS LIST
Note: It may not be necessary to use all the replacement plastic retaining clips supplied in the parts kit.
NECESSARY TOOLS AND MATERIALS

^ Two flat blade screwdrivers (approximately 8 inches and 12 inches long)
^ Long needle nose pliers
^ Medium needle nose pliers that have the nose bent at a 45 - 90~ angle. (These pliers are commercially available from most tool manufacturers.)
^ 10 mm 1/4 inch drive socket
^ 1/4 inch drive universal or a 1/4 inch drive 10 mm universal socket (optional)
^ Socket driver, 1/4 inch (power driver optional)
^ Ratchet, 1/4 inch drive
^ Wooden block approximately (2"X4"X8") for covering the latch on the floor.
^ Clean shop rags
^ Wax, grease and silicone remover (use one listed below or equivalent)
Dupont - Prepsol II (3929S)
PPG - Acryli-Clean (DX 330)
Kent - Acrysol (AB-S 20005)
3M - General purpose adhesive cleaner (08984)
^ Metalprep 79 by Amchem (or equivalent)
^ Galvaprep SG by Amchem (or equivalent)
^ Toyota touch-up paint - available from Toyota Parts Department.
^ Masking tape (1/4 or 1/2 inch wide)