Automatic Temperature Control

1. Remove undercover and center cluster from vehicle.
2. Reconnect to the check connector.





3. Place the temperature control lever at 77.
4. Run the engine at idle.





5. Check automatic temperature control.
a. Verify that the white line marked on the stem is positioned within the orange area on the power servo unit.
b. If the white line positions are not in the orange area, adjust as follows:





6. Adjust automatic temperature control.
a. Normally the orange adjusting terminal is connected.
b. If the white line on the stem is in the red area, change the connection to the red adjusting terminal.
.c If the white line is within the white area, change the connection to the white adjusting terminal.
7. Reinstall removed parts in reverse order.