US Vehicles

1. Connect a timing light to the engine.
2. Start the engine and let it idle.

Fig. 16 Check engine connector.:

3. Short terminals T and E1 of the check connector.





4. Loosen the set bolts and slowly turn the distributor until the timing marks, when illuminated by the timing light, indicate 10° BTDC.
5. Tighten the hold down bolts then ensure that the timing is still at spec. Torque bolts to 13 Nm (9 ft.lbs).
6. Remove the service wire from the check connector.





7. Timing should now be approximately 16° BTDC.