Gear Shift and Select Shaft Assembly Disassembly and Reassembly

Gear Shift and Select Shaft Assembly Disassembly and Reassembly

1. Push spring pins out using 2.8 - 3.0 mm (0.11 - 0.12 in.) commercially available spring pin remover and specified spring pin removers as shown below.
Special Tool
(A): 09922-85811 4.5 mm
(B): 09925-78210 6.0 mm
2. Inspect component parts for wear, distortion or damage. If any detect is found, replace detective part with new one.

NOTE:
^ When driving in spring pins, prevent shaft from being bent by supporting it with wood block.
^ Assemble 5th & reverse gear shift cam with its pit and spring pin aligned.
^ Make sure to select an appropriate spring by identifying the painted colors to keep gear shifting performance as designed.
- Low speed select spring - No paint
- Reverse select spring - Pink