Shift Cable: Adjustments

Adjustment
1. Shift select lever to "N".





2. Loosen cable end nuts and shift manual shift lever (3) to "N".

NOTE:
^ Make sure that nut and cable joint (4) have clearance under above conditions.
^ If select cable (2) has been moved, push it in arrow C direction as shown in the figure till it stops and then confirm that select lever is in "N" position.





3. Turn nut A by hand till it contacts manual select cable joint (1). Then tighten nut B with wrench.
4. After select cable was installed, check for the following.
^ Push vehicle with select lever shifted to "P". Vehicle should not move.
^ Vehicle can not be driven in "N".
^ Vehicle can be driven in "D", "2" and "L".
^ Vehicle can be backed in "R".