Rear

Preliminary Check
Preparation for toe inspection and adjustment.
^ Place vehicle in non-loaded state on level floor.
^ Set steering wheel in straight state.
^ Check that inflation pressure of each tire is adjusted properly and disc wheel is free from deflection.
^ Check that each suspension part is free from bend, dent, wear or damage in any other form.
^ Check that ground clearance at the right and left is just about the same.

Toe Inspection and Adjustment
1) Loosen right and left No.2 control rod (3) inner nuts (1).
2) Adjust toe to satisfy specification by turning right and left No.2 control rod inner bolts (cam bolts) (2) by the same amount.





3) After adjustment, tighten right and left nuts to specified torque while holding cam bolt with another wrench to prevent it from turning.
Tightening torque
No.2 control rod inner nut (a): 90 Nm (9.0 kgf-m, 65.0 ft. lbs.)
4) Install suspension frame cap.