Manual Road Test

This test checks the gears being used in "L", "2" or "D" range when driven with disabled gear shift control system. Test drive vehicle on a level road.
- With selector lever in "P" range, start engine and warm it up.





- After warming up engine, disconnect coupler of solenoid valve wire as shown in figure.
- With selector lever in "L" range, start vehicle and accelerate to 30 km/h (19 mile/h). Check in this state that 1st gear is being used.
- At 30km/h (19 mile/h), shift selector lever to "2" range and accelerate to 60 km/h (37 mile/h). Check in this state that 2nd gear is being used.
- At 60 km/h (37 mile/h), shift selector lever to "D" range and check that 3rd gear is used when speed is higher than 60km/h (37 mile/h).
- After above checks, stop vehicle then engine, and connect solenoid valve wire coupler.
- Clear DTC with scan tool.