Extension Case Oil Seal
REPLACEMENT1) Lift up the vehicle.
2) Clean the transmission exterior.
3) Remove the drain plug (ATF) to drain ATF.
CAUTION:
Directly after the vehicle has been running or the engine has been long idle running, the ATF is hot. Be careful not to burn yourself.
4) Tighten the drain plug (ATF).
NOTE:
Use a new gasket.
Tightening torque:
25 Nm (2.5 kgf-m, 18.4 ft-lb)
5) Remove the rear exhaust pipe. (non-turbo model).
6) Remove the center exhaust pipe (rear). (turbo model).
7) Remove the heat shield cover.
8) Remove the propeller shaft.
9) Using the ST, remove the oil seal.
ST 398527700 PULLER ASSY
10) Using the ST, install the oil seal.
NOTE:
Use a new oil seal.
ST 498057300 INSTALLER
11) Install the propeller shaft.
12) Install the heat shield cover.
13) Install the rear exhaust pipe. (non-turbo model)
14) Install the center exhaust pipe (rear).
15) Lower the vehicle.
16) Fill with ATF.
17) Bleed the air of control valve. Procedures
18) Check the level and leaks of the ATF. Inspection