Fuel Injector: Service and Repair
Fuel InjectorREMOVAL
RH SIDE
1. Release the fuel pressure.
2. Disconnect the ground cable from battery.
3. Open the fuel filler lid and remove the fuel filler cap.
4. Remove the intake manifold.
5. Remove clip (A) holding the engine harness to the fuel pipe protector RH, and remove the fuel pipe protector RH from the intake manifold.
6. Remove the harness band (A) which holds the engine harness to the fuel injector pipe RH.
7. Disconnect the connector from fuel injector.
8. Remove the bolts which hold fuel injector pipe RH.
9. Remove the fuel injector.
LH SIDE
1. Release the fuel pressure.
2. Disconnect the ground cable from battery.
3. Open the fuel filler lid and remove the fuel filler cap.
4. Remove the intake manifold.
5. Remove the fuel pipe protector LH from the intake manifold.
6. Remove the harness band (A) which holds the engine harness to the fuel injector pipe LH.
7. Disconnect the connector from fuel injector.
8. Remove the bolts which hold fuel injector pipe LH.
9. Remove the fuel injector.
INSTALLATION
RH SIDE
Install in the reverse order of removal.
NOTE: Use new O-rings.
Tightening torque: 19 N.m (1.9 kgf-m, 14.0 ft-lb)
LH SIDE
Install in the reverse order of removal.
NOTE: Use new O-rings.
Tightening torque: 6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
Tightening torque: 19 N.m (1.9 kgf-m, 14.0 ft-lb)
