Rear Door Latch: Service and Repair

Rear Door Latch and Door Lock Actuator Assembly

REMOVAL
1. Disconnect the ground cable from battery.
2. Remove the rear door trim.
3. Remove the wire from the rear inner remote.
4. Remove the sealing cover.
5. Remove the rear door glass.
6. Disconnect the door lock actuator connector.
7. Remove the screws, and remove the rear door latch and door lock actuator assembly.






INSTALLATION
Install each part in the reverse order of removal.

DOOR LOCK ASSEMBLY,
Tightening torque:
T1: 6.5 N.m (0.66 kgf-m, 4.8 ft-lb)
T2: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb)
T3: 18 N.m (1.84 kgf-m, 13.3 ft-lb)

NOTE: Make sure the child safety lock works correctly after installation.