Installation

INSTALLATION

PITCHING STOPPER

1) Install the pitching stopper.

Tightening torque:
T1: 50 Nm (5.1 kgf-m, 36.9 ft-lb)
T2: 58 Nm (5.9 kgf-m, 42.8 ft-lb)





2) Install the air intake boot assembly. (non-turbo model)
3) Install the intercooler. (turbo model)

TRANSMISSION REAR CROSSMEMBER AND REAR CUSHION RUBBER

1) Install the rear cushion rubber.

Tightening torque:
40 Nm (4.1 kgf-m, 29.5 ft-lb)

2) Install the transmission rear crossmember.

Tightening torque:
T1: 35 Nm (3.6 kgf-m, 25.8 ft-lb)
T2: 70 Nm (7.1 kgf-m, 51.6 ft-lb)





3) Remove the transmission jack.
4) Install the heat shield cover.
5) Install the center exhaust pipe. (non-turbo model)
6) Install the center exhaust pipe (rear). (turbo model)
7) Lower the vehicle.
8) Connect the battery ground terminal.