Installation

INSTALLATION

1) Install the select cable to plate assembly.

Tightening torque:
18 Nm (1.8 kgf-m, 13.3 ft-lb)





2) Install the select cable to the shifter arm.
3) Install the plate assembly to transmission.

Tightening torque:
T: 25 Nm (2.5 kgf-m, 18.4 ft-lb)





4) Install the washer and snap pin to the shifter arm.





5) Install new clamp paying attention to the installing direction.





6) Insert the tip of inner cable into connector hole of select lever, and fix the cable to bracket.





7) Shift the select lever to the "N" range, and then adjust the select cable position.
8) Install the heat shield cover.
9) Install the front exhaust pipe. (non-turbo model)
10) Install the center exhaust pipe (rear). (turbo model)
11) Lower the vehicle.
12) Connect the battery ground terminal.