Fuel Injector: Service and Repair
FUEL INJECTORREMOVAL
1. Release the fuel pressure.
2. Disconnect the ground cable from battery.
3. Open the fuel filler lid and remove the fuel filler cap.
4. Remove the clip (A) from the air intake boot.
5. Loosen the clamp (B) connecting the air intake boot and air cleaner case (rear).
6. Loosen the clamp (C) which connects the air intake boot and throttle body.
7. Remove the air intake boot from the throttle body, and move it to the left side wheel apron. (RH side only)
8. Disconnect the connector (A) from the mass air flow and intake air temperature sensor, and remove the clip (B) which holds the mass air flow and intake air temperature sensor harness. (RH side only)
9. Remove the suction hose (C) from the air cleaner case (rear). (RH side only)
10. Remove the air cleaner case (rear). (RH side only)
11. Remove the intake manifold protector.
- LH side
- RH side
12. Disconnect the connectors (A) from fuel injector.
13. Remove the bolts which hold fuel pipe onto the cam carrier.
14. Remove the fuel injector.
INSTALLATION
Install in the reverse order of removal.
NOTE: Use new O-rings, rubbers and seal rings.
Tightening torque: 6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
Tightening torque: 6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
- LH side
- RH side
Tightening torque: 3 N.m (0.3 kgf-m, 2.2 ft-lb)
