Installation

INSTALLATION

CAUTION:
When installing the ATF cooler pipe assembly on vehicle side, be careful not to bend the A/C pipe.

1) Install the ATF cooler pipe to the vehicle.

Tightening torque:
7.5 Nm (0.76 kgf-m, 5.5 ft-lb)

2) Install the A/C pipe to clip.
3) Install the battery cable bracket, and install the battery cable clip to the bracket.

Tightening torque:
7.5 Nm (0.76 kgf-m, 5.5 ft-lb)





4) Connect the harness connector to the A/C pressure switch.





5) Lift up the vehicle.
6) Install the ATF cooler inlet and outlet pipes.

NOTE:
Use a new washer.

Tightening torque:
T1: 25 Nm (2.5 kgf-m, 18.4 ft-lb)
T2: 40 Nm (4.1 kgf-m, 29.5 ft-lb)
T3: 45 Nm (4.6 kgf-m, 33.2 ft-lb)





7) Install the ATF AT inlet and outlet hoses to the ATF cooler pipe on the transmission side.

NOTE:
- Use a new ATF AT hose.
- Install so that the ATF AT hose is not folded over, excessively bent or twisted.
- Insert the ATF AT hose into the specified position.





8) Install the ATF radiator inlet and outlet hoses to the ATF cooler pipe on radiator side.

NOTE:
- Use a new ATF radiator hose.
- Install so that the ATF radiator hose is not folded over, excessively bent or twisted.
- Insert the ATF radiator hose into the specified position.





9) Install the heat shield cover. (turbo model)

Tightening torque:
3 Nm (0.3 kgf-m, 2.2 ft-lb)





10) Install the under cover.
11) Install the battery.
12) Check the ATF level. A/T Fluid Inspection

NOTE:
Make sure there are no ATF leaks in joints between the transmission, radiator, ATF cooler pipes, and ATF cooler hoses.